Swing Staging's own triangular rolling roof outrigger!

Remember these during assembly:

1. Insert each of the end telescopic square beams into each end of the middle square beam.
2. You must overlap them by 2 holes and then secure them by inserting two 5/8" bolts through the holes securing them with nuts.

The chart below shows the required counterweight needed for different lifting loads.
Please note: This chart is accurate only when the square telescopic beams are extended to their full length of 20 feet.
 

For more information on Swing Staging's triangular rolling roof outriggers please call a Swing Staging sales representative.